Can't you get your originals machined flat? I had mine done recently.
| ducatipaso.org http://ducatipaso.org/forum/ |
|
| I need new front rotors!!! where are people getting them http://ducatipaso.org/forum/viewtopic.php?f=1&t=2410 |
Page 1 of 1 |
| Author: | Johnnie [ Fri Apr 18, 2008 6:42 pm ] |
| Post subject: | I need new front rotors!!! where are people getting them |
I was out testing the duck and the front rotors are warped, what has everyone been using??? new from ducati??? aftermarket??? John |
|
| Author: | Skins [ Fri Apr 18, 2008 7:10 pm ] |
| Post subject: | Re: I need new front rotors!!! where are people getting them |
| Can't you get your originals machined flat? I had mine done recently. |
|
| Author: | Johnnie [ Fri Apr 18, 2008 8:12 pm ] |
| Post subject: | Re: I need new front rotors!!! where are people getting them |
I didnt think there was enough meat to turn a motorcycle rotor, where did you have them done? a bike shop or a regular machine shop? |
|
| Author: | Skins [ Fri Apr 18, 2008 8:59 pm ] |
| Post subject: | Re: I need new front rotors!!! where are people getting them |
| There certainly is enough meat on the original Paso 750 ones. I got mine done at a machine shop. |
|
| Author: | Tamburinifan [ Fri Apr 18, 2008 11:36 pm ] |
| Post subject: | Re: I need new front rotors!!! where are people getting them |
On most Duc rotors, 3,5mm thickness is service limit. EBC has spare ones f e. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|