good pix , thanks for that , probly saved me a bit of mental agony
| ducatipaso.org http://ducatipaso.org/forum/ |
|
| Paso Compatible Motors? http://ducatipaso.org/forum/viewtopic.php?f=1&t=4087 |
Page 1 of 1 |
| Author: | Zak [ Mon May 17, 2010 2:28 am ] |
| Post subject: | Paso Compatible Motors? |
Is there a list going at this point? I have a spare 916 motor, ECU, throttle bodies etc. just sitting and I was thinking it could be pretty mean to make a sleeper paso. Anyone know which motors' holes match up with the paso? Thanks, Zak |
|
| Author: | Mc tool [ Mon May 17, 2010 6:57 am ] |
| Post subject: | Re: Paso Compatible Motors? |
I once concidered fitting a 4 valve donk to my 906 but was advised that getting the rear cylinder head to fit was more of a issue than the bolt holes , which should be the same but to my eyes it always looked as if it would fit |
|
| Author: | ducapaso [ Mon May 17, 2010 9:13 pm ] |
| Post subject: | Re: Paso Compatible Motors? |
You can search the Boz's swithc to an 851 engine that can be installed in the frame without big efforts. |
|
| Author: | Desmo_Demon [ Wed May 19, 2010 1:15 am ] |
| Post subject: | Re: Paso Compatible Motors? |
| Author: | Mc tool [ Wed May 19, 2010 1:32 am ] |
| Post subject: | Re: Paso Compatible Motors? |
good pix , thanks for that , probly saved me a bit of mental agony
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|