| ducatipaso.org http://ducatipaso.org/forum/ |
|
| Bottom-end compatibility 750 <> 907ie http://ducatipaso.org/forum/viewtopic.php?f=1&t=4906 |
Page 1 of 1 |
| Author: | 907ie toolkit owner [ Wed Jun 29, 2011 7:16 pm ] |
| Post subject: | Bottom-end compatibility 750 <> 907ie |
Can anyone give a quick but well informed answer to this naiive question: Is the bottom-end of the 750 the same as for the 907? Can I rebuild the heads from the 907ie onto a 750 bottom-end, with all its auxiliary stuff like water pump?? thanks Easier to get an answer here than hope I get the answer right by inspection / documentation review. |
|
| Author: | paso750 [ Wed Jun 29, 2011 8:18 pm ] |
| Post subject: | Re: Bottom-end compatibility 750 <> 907ie |
no it`s not. The 750 is an oil cooled, 5 speed gearbox engine with 88mm pistons, the 907ie is a water cooled, 6 speed gearbox engine with 92mm pistons. Due to the different gearbox the 907ie engine case is a little wider and the cylinder stud distances are bigger due to the larger pistons. Of course the engine case opening for the cylinders is also larger. G. |
|
| Author: | 907ie toolkit owner [ Wed Jun 29, 2011 11:30 pm ] |
| Post subject: | Re: Bottom-end compatibility 750 <> 907ie |
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|