| Attachments: |
|
Unbenannt-1.jpg [ 110.23 KiB | Viewed 8244 times ] |
| ducatipaso.org http://ducatipaso.org/forum/ |
|
| Doing the 900ss CV carb swap http://ducatipaso.org/forum/viewtopic.php?f=1&t=7429 |
Page 1 of 1 |
| Author: | viper1 [ Wed May 11, 2016 11:25 am ] |
| Post subject: | Doing the 900ss CV carb swap |
I decided to pick up a set of 94 900ss carbs to toss on the 750. I'm sick of dealing with the Weber issues! Whats all needed to make the switch? The carb manifolds & rubber gaskets. I'll end up getting separate filters....anything else I need to get or should know? |
|
| Author: | paso750 [ Wed May 11, 2016 2:13 pm ] |
| Post subject: | Re: Doing the 900ss CV carb swap |
check the Technical FAQs |
|
| Author: | viper1 [ Thu May 12, 2016 1:25 am ] |
| Post subject: | Re: Doing the 900ss CV carb swap |
| Author: | paso750 [ Thu May 12, 2016 6:58 am ] | ||
| Post subject: | Re: Doing the 900ss CV carb swap | ||
|
|||
| Author: | viper1 [ Thu May 12, 2016 11:09 am ] |
| Post subject: | Re: Doing the 900ss CV carb swap |
| Author: | Rickman [ Thu Sep 20, 2018 1:47 pm ] | ||
| Post subject: | Re: Doing the 900ss CV carb swap | ||
I just did mine, and I am using a small vacuum fuel pump, (3psi), with a return line that t's off just before the carbs. All the info was on the forum.
|
|||
| Author: | Rickman [ Mon Sep 24, 2018 2:44 pm ] |
| Post subject: | Re: Doing the 900ss CV carb swap |
I'm setting mine up this week, once the carbs are on, you'll need a small vacuum fuel pump, i replaced the screw in my intake manifold with an M5 x 6mm brass fitting, my fuel line comes out of the tank and goes to a fuel filter, then the vacuum fuel pump then to a t or y, one line will go to the carb and the other is a return back to the tank. They also recommend a small bottle for the two vent tubes and the float bowl overflow line also. Once mine is set up, I'll add some pics if you'd like. -Rickman |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|