Dyna DC10-1

reo · **Posted:** Sun May 01, 2016 9:47 am

Hello.
Can anyone tell me where I plug connectors to the terminals on a Dyna DC10-1 coil ??

I do not understand completely if it's + and - terminals.

reo

Derek · **Posted:** Sun May 01, 2016 11:43 am

The +ve terminals should both be connected to the 12v ignition supply (I believe it is yellow/green on the 750S). The -ve terminals should be connected to the ignition modules, the vertical coil to the vertical module (grey wire?) and the horizontal coil to the horizontal module (light blue / yellow wire?).

reo · **Posted:** Sun May 01, 2016 12:41 pm

Thanks for reply.
What I do not quite understand is if it is +/- on the coil. There are no marks showing who is + and who are-
I also has sent a request to Dynatec but waiting for a response.

reo

paso750 · **Posted:** Sun May 01, 2016 3:52 pm

the side with the printing is +, the side the ignition wire is -

reo · **Posted:** Sun May 01, 2016 4:33 pm

Thank you for your answer. Appreciate it.
As it appears on my image of the coil is missing the + mark on this. Dont know why.

reo

Derek · **Posted:** Mon May 02, 2016 8:10 am

Ah! A bit tricky with unmarked coils. :huh:

higgy · **Posted:** Mon May 02, 2016 10:03 am

FYI, The info is downlaodable from Dyna in the installation instructions. Section 4 :idea:

basically it states the positive terminal is the one opposite the spark tower :thumbup:

Dyna DC10-1

Who is online