Okay i have to put the rear back together so I can move the bike and I cant get the swing arm back on.
The Swingarm "Axle" goes thru the frame, the 3" (est) bushing and big spacer goes up against the motor.
(Or atleast that's the way I remember) But the gap is to small to fit. about a 1/16" maybe??
Looking at the image, the left side has a bushing already installed. The right side has the needle bearings, but needs a bushing for the axle bolt to go thru.
What am I missing ?? Looked at schematics on line and cant figure out what I am missing
And what the F^^% is this. Was attached to the bottom of the swingarm bu a small bolt (now broken off)
And whay type of mudflap goes above the swingarm to the frame? All I had was 2 brackets
Thanks
in the Nelson sun . I gave the neibour some wild pork salami and he gave me some wild venison chops and then we made a pact to kill the other neibours cat , and thus ,apart from being stranded in my own pool ( dived in ..... couldnt get my broken body out ) which was getting "funnier " by the minute as I really needed a piss , I have had a good day! Oh , back to the sheep shaggin' are we ,well I'm getting real bored with that ... yeah ,I bin doin' the same one for ages 