| ducatipaso.org http://ducatipaso.org/forum/ |
|
| 907 brakes http://ducatipaso.org/forum/viewtopic.php?f=3&t=1484 |
Page 1 of 1 |
| Author: | tewsy [ Sat Dec 02, 2006 9:26 am ] |
| Post subject: | 907 brakes |
| Author: | Finnpaso [ Sat Dec 02, 2006 10:02 am ] |
| Post subject: | |
| Author: | tewsy [ Sat Dec 02, 2006 1:32 pm ] |
| Post subject: | |
| Author: | jcslocum [ Sat Dec 02, 2006 2:10 pm ] |
| Post subject: | |
| Author: | Finnpaso [ Sat Dec 02, 2006 2:13 pm ] |
| Post subject: | |
| Author: | tewsy [ Sat Dec 02, 2006 9:19 pm ] |
| Post subject: | |
| Author: | wilbur [ Sun Dec 03, 2006 2:57 am ] |
| Post subject: | |
| Author: | Finnpaso [ Sun Dec 03, 2006 9:11 am ] |
| Post subject: | |
| Author: | tewsy [ Sun Dec 03, 2006 10:38 am ] |
| Post subject: | |
| Author: | jcslocum [ Sun Dec 03, 2006 1:39 pm ] |
| Post subject: | |
| Author: | Finnpaso [ Sun Dec 03, 2006 8:46 pm ] |
| Post subject: | |
Little strange, if ONLY "left" seems to be out of measurements??? :confused: Normally there is not ANY shim plates in front axle...  Can You take some close fotos??? My mail: finnpaso@gmail.com can load fotos. If someone need those from me, i can resend easily, but then need address surely...
Btw, are rotors original???? I mean designed to 907IE .... |
|
| Author: | tewsy [ Fri Dec 08, 2006 10:27 am ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|