I was about to do the wiring mod that involves adding a relay to isolate the ignition switch from the main power. This:
https://app.box.com/s/64zvqpl6sf303gt44wu6
The images and comments below illustrate my confusion. There are various versions of this mod description scattered around the forums. Most are unclear about how to wire this relay. I found one write up regarding the Paso 750 that I thought spelled it out:
http://www.desmodemon.com/paso_project_5.html
Maybe this is obvious, but, as usual, it wasn't to me, and the description linked in the 907ie FAQ could mislead someone who is electrically challenged, like me.
Carry on.
| Attachments: |
|
File comment: The main diagram of the mod in the 907ie FAQ link shows the new relay, with pins not marked. relayunmarked.png [ 16.32 KiB | Viewed 12819 times ] |
|
File comment: The next page in the 907ie mod link has an image of a relay with conventional pin wiring. However, I don't think this is how the relay should be wired in this case. relayasshown.png [ 45.82 KiB | Viewed 12819 times ] |
|
File comment: An image from a document in the Paso 750 area called [b]The Paso Project [/b]seems to show the correct wiring pattern, although you don't need a 5 pin relay. This page, middle diagram: http://www.desmodemon.com/paso_project_5.html relaypaso750.png [ 41.88 KiB | Viewed 12819 times ] |
