| ducatipaso.org http://ducatipaso.org/forum/ |
|
| rear hub, bearing, and seals needed http://ducatipaso.org/forum/viewtopic.php?f=4&t=1492 |
Page 1 of 1 |
| Author: | Ryan [ Wed Dec 06, 2006 11:02 pm ] |
| Post subject: | rear hub, bearing, and seals needed |
need these parts, or part numbers, rear hub"carrier", ie don't launch bike @ 10.000rpms on roll...very messy...hub bearings, and seals. any help appreciated. p.s. usually the bike would wheelie while smoking down the rear tire, looks kool as heck, but ugly when it "hooks"....won't be doing that anymore. Thanks, Ryan oops, 88' 750 californian, delta rim |
|
| Author: | wilbur [ Wed Dec 06, 2006 11:26 pm ] |
| Post subject: | |
What year bike would help. I'm not sure 907 and Paso the same. :thumbup: |
|
| Author: | wilbur [ Thu Dec 07, 2006 1:28 am ] |
| Post subject: | |
Ryan, Take a look in the DOWNLOADS section for a Paso parts manual. If your wheel is the same 16" Delta wheel of the 750 and 906 Paso. You are good to go. :thumbup: |
|
| Author: | persempre907 [ Thu Dec 07, 2006 11:05 am ] |
| Post subject: | |
I haven't understood about the "rear hub carrier". No matter, the Oscam wheels of 750 and 906 are the same, except for the colour. Ciao |
|
| Author: | Finnpaso [ Thu Dec 07, 2006 1:25 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|