Rubber cap hor. cylinder - 906/907

duske · **Posted:** Tue Mar 25, 2014 3:27 pm

Hi.

Can anyone help med with the rubber cover for the belts. It is the one for the horizontal cylinder.

Ducati partnumber : 23510061A

http://www.stein-dinse.biz/Komplettange ... :8598.html

Mc tool · **Posted:** Tue Mar 25, 2014 9:54 pm

I had to rebuild mine as it was cracked around where the screws go in . I would have a look at the later model 2 valve motors , I aint sure ( G probly knows

) but I would think that the later SS motors would have the same piece on them and it may be available under a different part #
http://www.oiltalavante.com/DUCATI-23510061A/en . I just had a quick look and this lot have one for 15 euro , I have no idea where they are
H

duske · **Posted:** Wed Mar 26, 2014 7:19 am

Hi.

I have a order pending at them, but they are not able to get it. Have also tried Stein Dinze but no luck.

I will try to look at the other models to see if they could fit - thanks.

Derek · **Posted:** Wed Mar 26, 2014 10:56 am

it's the same part on all the 904/944 engines - SS, Monster, ST2

paso750 · **Posted:** Wed Mar 26, 2014 11:21 am

actually it`s not http://www.stein-dinse.biz/Komplettange ... tyPhoto/0/ but if that tongue is cut off it probably will be.

duske · **Posted:** Wed Mar 26, 2014 12:48 pm

I have ordered this and will try a small modification. I will report back if it works...

Derek · **Posted:** Wed Mar 26, 2014 7:50 pm

Rubber cap hor. cylinder - 906/907

Who is online