Anyone here have a picture and dimensions of the swingarm pin for the rear-brake, caliper bracket? On the parts list, it is #037740070. This is the pin that is bolted to the inside of the swingarm to prevent the caliper bracket from rotating. I picked up a used 907 swingarm needing some work and it is missing this piece. The pin is no longer available from Ducati, so I was wondering what it looks like and it's dimensions so I can make one. Thanks!

Also, anyone have the left swingarm end cap that the axle adjustment bolt goes through (part #37310041A)? This is still available, but at $35 plus shipping, it is more than I spent on the complete swingarm.

Isn`t that the same pin on the 93-99 Monster swing?
Ought to be avaliable.

if it is the same as on a Monster swingarm, then it is the same as on an 888 also.



btw I would have all the parts you need but as a set and only shipment would cost more than what they ask for that part in US.

G.

is is noticeable I currently have time ?





the bolt is a grade 8.8.

G.

the pictures and measurements are made from a spare 907ie swingarm I`m keeping for similar reasons as you do

RE Rear caliper bracket , 907 , Check US ebay - RPM CYCLE PARTS.....$30.00. BUY NOW. Hope its OK, .......Marty