swingarm width 24cm. Terry what`s the wheel width with the sprocket carrier on ?

G.

c'mon guys.....
check this size and when you came in naples you'll have a great birra and pizza payed!!

...... I forgot to take the measurements, again. I'm sorry. I got involved in putting the front end back on my Harley. I thought about the measurements while putting the bike back together, but I then got side-tracked by our three year-old daughter. I'll get those measurements very soon.

Hurray!!! Hurray!!!.....I got the measurements, but....

I left the paper that I wrote them onto sitting on my work bench.

I'll call my wife in an hour or two and get her to read them to me over the phone......I'm such a slack-ass.



Edit - Here are the measurements if I did the conversions correctly for the '94 Supersport 900 rear wheel (4.5" width)..

1) Hub width with sprocket carrier installed - 206mm
2) Hub width without carrier - 171mm
3) '92 907 rear caliper bracket width - 35mm (Correction: it is 28mm wide, NOT 35mm....sorry)

I'd probably 1-2 mm difference because of the inch measurements and my conversions.

demon you 'll be my guest when you'll come in naples

mmmmmmm
Today i assemble all my elements of the swingarm and i noticed that there isn't any spaces for any spacers.....
i add some pictures
what do you think????

From what modell is that Your rear brake caliper holder, cause seem, that caliper will come UNDERside, not upper, like normally ???

I think, that if U dont have any space for spacers, then Your only problem will be chain line and it can be "modified" with different offset rear sprockets.... Ducati make manykind of different offset front sprockets and u can use also spacers in front sprocket to adjust chain line.... I havent read hole topic, so peg me pardon, if i talk something "shit" now...

mmm i hope it is like you say.....
but i'm not convinced so much....

I can take a measurement of the spacer on an ST2 wheel to see how much it projects from the sprocket carrier, if you need. The other measurements of the spacer would not be any good to you, as the axle diameter of the ST2 is 25mm, so the ID of the spacer and OD of the smaller side would be significantly different for a spacer for a 17mm axle. Gerhard, do you have a 907 spacer you can measure?

My ST2 spacer is just out of its place, so:

Thickness is 8,67mm(hahahahaha) from digital gauge.
Inner hole diameter is 30.05mm
Outer diameter from bigger end(to outside/swingarm side) is: 45.00 mm
Outer diameter from smaler end(to inside/wheel side) is: 35,50 mm (about)

looks exact, like in Desmo_Demons drawing