hi paso enthusiasts
I had my headers done by jet hot and they had been pulled apart, now I need to re-install them but they dont line up, as mine are adjustable and not sure if I need to change the L/H side further out or R/H side in
can someone please tell me the measurement in comparison to the bottom frame, both measurements, vertical and horizontal would be great (ie 15mm down and 15mm out from frame)
any help would be appreciated
this measurement is at end of headers-start of cans

after staffing around and changing a few original settings I think I got it right
in any case, the settings on this would be different to any original setup...thanks anyway